LS-GL(Debian lenny)Boot sequence

Orion1   CPU =  Low

=== BUFFALO LS-GL U-Boot. ===
 ** LOADER **
 ** BUFFALO BOARD: BUFFALO_BOARD_LS_GL LE (CFG_ENV_ADDR=fffff000)


U-Boot 1.1.1 (Apr 18 2007 - 18:35:44) Marvell version: 1.12.1 - TINY

DRAM CS[0] base 0x00000000   size 128MB
DRAM Total size 128MB
[256kB@fffc0000] [0kB@f8000000] ## Unknown FLASH at f8000000: Size = 0x00000000 = 0 MB
Flash: 256 kB
Addresses 20M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (20M - 16M): Done

Soc: 88F5182 A2
CPU: ARM926 (Rev 0) running @ 400Mhz
Orion 1 streaming disabled
SysClock = 200Mhz , TClock = 166Mhz


USB 0: host mode
USB 1: host mode
PCI 0: PCI Express Root Complex Interface
PCI 1: Conventional PCI, speed = 33000000
Net:   egiga0 [PRIME]
Using 88E1118 phy

Marvell Serial ATA Adapter
Integrated Sata device found
  Device 0: OK
Model: ST3750640AS                              Firm: 3.AAD    Ser#:             5QD1MGW5
            Type: Hard Disk
            Supports 48-bit addressing
            Capacity: 715404.8 MB = 698.6 GB (1465149168 x 512)

Using device ide0, partition 1

Loading from block device ide device 0, partition 1: Name: hda1
  Type: U-Boot  File:/initrd.buffalo

2322728 bytes read
Using device ide1, partition 1
** Bad partition 1 **
Booting from Device 0
hit any key to switch tftp boot.
Hit any key to stop autoboot:  0
Hit any key to stop autoboot:  0

Reset IDE:
Marvell Serial ATA Adapter
Integrated Sata device found
  Device 0: OK
Model: ST3750640AS                              Firm: 3.AAD    Ser#:             5QD1MGW5
            Type: Hard Disk
            Supports 48-bit addressing
            Capacity: 715404.8 MB = 698.6 GB (1465149168 x 512)

Using device ide0, partition 1

Loading from block device ide device 0, partition 1: Name: hda1
  Type: U-Boot  File:/uImage

1813332 bytes read
<<stop_sound>>
## Booting image at 00100000 ...
   Image Name:   linux
   Created:      2009-07-28  16:45:46 UTC
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1813268 Bytes =  1.7 MB
   Load Address: 00008000
   Entry Point:  00008000
   Verifying Checksum ... OK
OK

Starting kernel ...

arg:netconsole=6666@192.168.11.150/,@192.168.11.149/ root=/dev/sda2 rw
Uncompressing Linux................................................................................
........................................ done, booting the kernel.

Debian GNU/Linux lenny/sid
LS-GL.sundays.dip.jp login:


トップ   編集 凍結 差分 バックアップ 添付 複製 名前変更 リロード   新規 一覧 単語検索 最終更新   ヘルプ   最終更新のRSS
Last-modified: 2018-01-03 (水) 21:45:50 (704d)